Shimano Sti Pair Of Cable Stops
-
Shimano Sti Pair Of Cable Stops
Review this store
Cycling
Shimano
Shimano STI Pair Of Cable Stops: Pair of Shimano STI Cable Stops
£10.79
Visit Store »
Similar Products
 
|
Shimano Atb Brake Cable Set Cycling Shimano Shimano ATB Brake Cable Set is a replacement cable set for front and rear mountain bike brakes, includes inner and outer cable. Review this product |
 Review this store |
£14.99 |
Visit Store » |
|
Gore Bike Wear Rideon Low Friction White Brake Cable Kit Cycling Gore Bike Wear Gore Bike Wear RideOn Low Friction White Brake Cable Kit: For use only on road bikes, this high performance cable system replaces galvanized, stainless steel, and other coated cables. Patented cable coating technology designed for low friction and durability. Designed to work mainly with road bikes but will work with MTB. There are two different lengths of cables in the kit. The longer cable and liner is for the rear brake, the shorter cable and liner is for the front brake. Each cable has 2 end terminations - a barrel end (mountain bike) and a pear end (road bike). Select the end that corresponds to your type of brake and remove the end termination you will not be using. Remove old cables and housing; note cable routing and location of ferrules. Using old housing pieces as a pattern, cut new housing lengths to match. Using wire cutters and awl make sure housing ends are free of burrs and wide open. Install new housing into place on bike. Turn barrel adjusters to fully clockwise. Carefully feed new cable through new housing and cable housing stops, adding ferrules as needed - nosed ferrules are to be used at the cable stops, the non-nosed ferrules should be used at the brake lever (if needed) and brake caliper. With cable held taught, secure it in pinch bolt and tighten to brake manufacturer's torque requirements. Trim off excess cable and crimp a cap on cable end. Slide red crimp cap cover over crimp cap. Adjust brakes as usual. Review this product |
Review this store |
£26.91 |
Visit Store » |
|
M:part Micro Inline Gear Cable Tension Adjusters - Pair Cycling M part M:Part Micro Inline Gear Cable Tension Adjusters - Pair allows on-the-fly fine adjustment of the gear cable tension. Simply cut your gear cable outer and fit these between the two ends. Ideal for indexed gears especially when used with Road STI levers. Complete with all outer cable end caps. Ultra lightweight compact design. Supplied as a pack of two. Review this product |
Review this store |
£6.99 |
Visit Store » |
|
M:part Inline Gear Cable Tension Adjusters With Grease Port - Pair Cycling M part The M:Part Inline Gear Cable Tension Adjusters with Grease Port - Pair allows on-the-fly fine adjustment of the gear cable tension. Simply cut your gear cable outer and fit these between the two ends. Ideal for indexed gears especially when used with Road STI levers. Features built in grease port allowing you to maintain the performance of your gear cable. Complete with all outer cable end caps. Supplied as a pack of two. Review this product |
Review this store |
£7.99 |
Visit Store » |
* Must be complete